AIR1BBG, Lub Airmatic PDI 1.5L W/LLS 220V

(No reviews yet) Write a Review
Condition:
New
Availability:
Y
Weight:
10.00 LBS
Shipping:
Calculated at Checkout
On Sale
  • AIR1BBG, Lub Airmatic PDI 1.5L W/LLS 220V
  • AIR1BBG, Lub Airmatic PDI 1.5L W/LLS 220V
MSRP: $1,098.64
Now: $980.53
Was: $1,019.76
— You save $118.11

Description

Application

The Airmatic lubricator is for use with cyclic oil lubrication systems. The unit can be used with single line resistance (SLR), positive displacement injector (PDI), progressive distribution and injector systems.*

Operation

Airmatic® lubricator includes an air actuated, spring return piston pump with an adjustable output between 2 to 10cc for each piston stroke at discharge pressures up to 500 psi. Oil output is related to piston travel and cycles per unit time. Stroke movement is preset to a fixed discharge and supply air pressure governs the output delivery pressure. When used with positive displacement injectors, a built-in pressure relief device lets the PDI reset after discharge. For extended service, incoming air must be dry. Always use a suitable FRL unit (filter/regulator/ lubricator) to control air to recommended operating range. Normally, the air-operated Airmatic is used with a 3/2-way electrical solenoid valve (optional) to control and vent shop air from the pump air inlet. All models are available with optional 3/2-way valve. To adjust lubricant delivery, loosen locknut on hex socket adjusting screw (see Figure 1 on right). Turn delivery adjusting screw clockwise to reduse discharge – use graduated label as guide, set to desired setting and tighten locknut (insert shows setting at 8cc). For PDI systems, maximum discharge of 10cc/stroke is recommended.

System Design

If the distribution system incorporates extensive use of flexible lines, a slightly larger discharge must be used to compensate for the resiliency of the flexible connections. Solve for the following “R” value and ADD this amount to the required pump discharge:

+ R = .030 x feet of 5/16” O.D. flexible hose

+ R = .035 x feet of 7/16” O.D. flexible hose

View AllClose

Additional Information

Bijur Part Number:
AIR1BBG
Reservoir Capacity:
1— 1 liter plastic reservoir
Output Mode (System Type):
B— PDI (positive displacement injector)
Level Switch:
B— With level switch
Solenoid Valve:
G— 220V solenoid, with DIN connector
View AllClose